Control Functions - Jøtul GF 370 DV II Installation And Operation Instructions Manual

139467_03 GF 370 DV II June 2015

Control Functions

Pilot Mode
Set the stove switch to CPI mode for Proflame 2
remote control. The IPI/CPI functionality will be
controlled by the remote transmitter.
Burner Control
Set the stove burner switch to ON for Proflame 2
remote control.
OFF - Turns off both remote and manual burner
functionality. Switch to OFF when the stove will not be
used for an extended period of time.
Remote Transmitter
The Transmitter features a simple button layout and
informative display screen. See figs. 51-52.
LCD DISPLAY - graphically indicates temperature
settings and status of the Thermostat, Burner, Fan, and
Accent Lamp.
ON / OFF Key - controls Burner, Fan, and Lamp functions.
THERMOSTAT Key - Used to set either Manual or
Thermostatic Control and index through thermostatic
functions.
UP / DOWN Arrow Key - Selects thermostat
temperature range, fan speed, and flame height.
MODE Key - used to select the component to be
controlled: CPI/IPI, Burner, Fan, and Accent Lamp.
The Wall Mount Bracket can be used for convenient
Transmitter storage.
Transmission
Thermostat
ON / OFF / SMART
Set Point
Temperature Level State
Burner
Modulation
Fan Modulation
Figure 41. Remote transmitter display data.
24
Child Safety Lock-out
°F
°C
OFF
ON
SMART
MAX
MAX
Lamp - ON / OFF
Initializing the System
1. Press the Controls Access Door to release the magnetic
catch and swing the panel down.
Switch the Burner to OFF.
2. Install three AAA batteries into the Transmitter.
3. Press the black (or red) button on the left front corner
of the IFC board, next to the controls switch plate.
The board will "beep" three times and a yellow LED
indicates a 10-second synchronization time limit.
4. Within the 10-second time frame, push the ON button
on the Transmitter. The IFC will "beep" four times to
indicate that it has acknowledged the transmitter
command and sets to the particular code of that
Transmitter.
5. After initialization, the burner switch must be placed
in the ON position and Pilot Mode switch placed in CPI.
The remote can then be used to control the burner.
To return to full Manual functionality, hold the red or
black initialization button down until it "beeps" three
or four times and the yellow LED illuminates. Within
10 seconds, push the button again until it signals the
acknowledgement.
Figure 40.
Remote
transmitter
function keys.
Low Battery Alarm
Room
Temperature
CPI Mode
AUX
(Not Applicable)
Split Valve
(Not Applicable)
Blue LCD Screen
ON/OFF Key
THERMOSTAT Key
UP/DOWN Key
MODE Key