Jøtul GF 370 DV II Installation And Operation Instructions Manual page 19

Panel Retainer
Figure 25. Loosen the panel retainer screws.
Rear Glass Panel
Figure 26. Install Rear Glass Panel.
Figure 26a. Install Side Glass Panels.
Bracket
8. Install Burner Media
River Rocks
CAUTION: THE ROCKS ARE FRAGILE! SUPPORT THE
ASSEMBLY FROM THE BOTTOM AND HANDLE CARE-
FULLY!
1. Engage the River Rock bed with the two center
burner pins as shown in fig. 27. Either side of the
rocks may face outward as desired.
2. Evenly disperse the Ember Stones supplied over
the burner plate around the log parts. DO NOT
ALLOW EMBER STONES TO BLOCK THE PILOT AS-
SEMBLY AREA. The carry-over ports directly in front
of the pilot must remain clear for proper pilot
ignition. See figs. 29 and 65 for examples.
StarFire Glass Embers
Do not use more than the four pounds (in two, 2 lb.
bags) of glass media provided. For best results, evenly
spread the contents of the bag over the entire burner
plate and rear skirt, mounding a crown toward the
center.
DO NOT COVER THE AREA IMMEDIATELY IN FRONT OF
THE PILOT ASSEMBLY. The carry-over ports directly in
front of the pilot assembly must be clear to ensure proper
pilot ignition. See fig. 66 page 34.
Figure 27. Set River Rock assembly on pins.
139467_03 GF 370 DV II June 2015
19