Program The Remote Code - AT&T 984 User Manual

984CIB_(Rev3)28.04.06
n n n
n n
i i i
i i
50
4/28/06 6:28 PM Page 50

Program the remote code

You can change the remote code (password) used to
access your phone remotely.
1. Press E to begin feature setup.
2. Press - until the screen display includes
DTAD/AA.
3. Press E. The screen display includes
ANSWERxSTATUS.
4. Press - until the screen display includes
REMOTE CODE.
5. Press E. The screen display includes
REMOTE CODE and the current code.
6. Use the dial pad to enter a three-digit remote
code, then press - to save the new code. The
screen display includes MESSAGE LENGTH.
7. Proceed to step 5 on page 51 to set the next
feature (message length).
—OR—
Press and hold E to return to the idle
screen.
NOTE: You can exit feature setup and return to the
idle screen any time. Simply press and hold E.