Remove Messages; Record A Memo - AT&T 984 User Manual

984CIB_(Rev3)28.04.06
i i i
i i
i i i
i i
108
4/28/06 6:28 PM

Remove messages

Remove a selected message
You can remove a message while listening to it. Press
r while the message you want to erase is playing.
The screen display includes Removed! and the message
number you erased.
The answering system immediately plays the next message.
Remove all messages
1. Press d to access the answering system.
n n n
n n
2. Press - until the screen display includes
REMOVExALLxMSGS.
i i i
i i
3. Press E. The screen display includes
Removexall?
4. Press E again within three seconds to
confirm the command. The screen displays
AllxRemoved! briefly and then changes to
display RECORDxMEMO.
NOTE: If you try to remove all messages when
you have new (unreviewed) messages, you will hear
an error tone. The DTAD will not remove any
messages.
NOTE: To exit DTAD and return to the idle screen
at any time, press d.

Record a memo

You can record a memo to be played back later with the
incoming messages.
1. Press d to access the answering system.
2. Press - until the screen display includes
n n n
n n
RECORDxMEMO.
i i i
i i
3. Press E. After the beep, start recording
your memo. The screen display includes Memo
Recording.
4. Press E to stop recording. The screen
displays the number of messages and RECORD
MEMO.
NOTE: To exit DTAD and return to the idle screen
at any time, press d.
Page 108