Daytime Running Lights(Day Light) - Skoda 2013 Rapid Owner's Manual

The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty

All seats occupied, boot empty

All seats occupied, boot loaded

Driver seat occupied, boot loaded

WARNING
Always adjust the headlight beam to meet the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehicles.
■
The beam range is sufficient for safe driving.
■
Note
We recommend you adjust the headlight beam when the low beam is switched
■
on.
An audible warning signal will sound if the light switch is in the  or  posi-
■
tion, the ignition key is removed and the driver's door is opened. The audible
warning signal is switched off after a few seconds or as a result of door contact
when the driver's door is closed. However, the side lights remain on to illuminate
the parked vehicle if necessary.
If leaving the vehicle without needing the parking lights on, always turn the
■
light switch to position .

Daytime running lights(DAY LIGHT)


First read and observe the introductory information and safety warn-
ings on page 41.
The daytime running lights function provides the lighting of the front of the vehi-
cle.
Switching on daytime running lights
›
Turn the light switch » Fig. 21 on page 41 to position .
Deactivating the daylight driving lights function
›
Deactivate the daylight driving lights by removing the fuse for the daylight driv-
ing lights » page 197, Fuses in the dash panel.
42
Using the system
Activating the daylight driving lights function
›
Activate the daylight driving lights by inserting the fuse with the appropriate
amperage for the daylight driving lights
Deactivating daytime running lights on vehicles with the START-STOP system
›
Switch off the ignition.
›
Pull the turn signal lever » Fig. 22
while simultaneously pushing it downwards, and hold it in this position.
›
Switch on the ignition – wait until the left-turn signal light flashes 4x.
›
Switch off the ignition – an audible signal sounds which confirms the deactiva-
tion of the daytime running lights.
›
Release the turn signal lever.
Activating daytime running lights on vehicles with the START-STOP system
›
Switch off the ignition.
›
Pull the turn signal lever » Fig. 22
while simultaneously pushing it upwards, and hold it in this position.
›
Switch on the ignition – wait until the right-turn signal light flashes 4x.
›
Switch off the ignition – an audible signal sounds which confirms the activation
of the daytime running lights.
›
Release the turn signal lever.
The daytime running lights are switched on automatically if the following condi-
tions are met:
The ignition is switched on.

The daylight driving lights function is activated.


The light switch » Fig. 21 on page 41 is in position .

Note
When the daytime running light is switched on, the side lights (neither at the
front nor the rear) and the number plate lights are not lit.
» page 197, Fuses in the dash panel.
on page 43 towards the steering wheel
on page 43 towards the steering wheel
