Daytime Running Lights(Day Light) - Skoda 2014 Rapid Spaceback Owner's Manual

Switching on the parking light or parking lights

Switch on low beam
1)

Pull switch
Switch on the front fog lamp

Switching on the rear fog light

 Headlight range control
Turning the dial » Fig. 39 from the position
B
justment is gradually adjusted and thereby shortens the light cone.
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty

All seats occupied, boot empty

All seats occupied, boot loaded

Driver seat occupied, boot loaded

We recommend you adjust the headlight beam when the low beam is switched
on.
WARNING
Always adjust the headlight beam to meet the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
An audible warning signal will sound if the light switch is in the  or  posi-
■
tion, the ignition key is removed and the driver's door is opened. The audible
warning signal is switched off after a few seconds or as a result of door con-
tact when the driver's door is closed. However, the side lights remain on to illu-
minate the parked vehicle if necessary.
If leaving the vehicle without needing the parking lights on, always turn
■
the light switch to position .
1) On vehicles with the instrument cluster - Version 1
switch.
» page 63
1)
» page 61
» page 61

in  means the headlight ad-
» page 30 the symbol  also illuminates on the light

Daytime running lights(DAY LIGHT)


Read and observe on page 58 first.
The daytime running lights (the only function) provides the lighting of the front
vehicle range.
The lights are switched on automatically if the following conditions are met.
The light switch is in the position  or 

The ignition is switched on.

The parking aid is activated.

Deactivating the function
›
Switch off the ignition.
›
Remove the fuse for the daytime running lights
dash panel.
Activating the function
›
Switch off the ignition.
›
Use a fuse of appropriate amperage for the daytime running
lights » page 173, Fuses in the dash panel.
Disable function on vehicles with the START-STOP system or with the
automatic driving light control
›
Switch off the ignition.
›
Slide the turn signal light lever
it in this position.
›
Switch on the ignition – wait until the left-turn signal light flashes 4x.
›
Switch off the ignition – an audible signal sounds which confirms the deacti-
vation of the function.
›
Release the turn signal stalk.
Function on vehicles with the START-STOP system or with the automatic
driving light control
›
Switch off the ignition.
›
Slide the turn signal light lever
this position.
›
Switch on the ignition – wait until the right-turn signal light flashes 4x.
›
Switch off the ignition – an audible signal sounds which confirms the activa-
tion of the function.
» Fig. 39 on page 58.
» page 173, Fuses in the
(» Fig. 40 on page 60) downwards and hold
(» Fig. 40 on page 60) upwards and hold it in
Lights and visibility

59