Skoda 2013 Rapid Owner's Manual page 29

Reseting
›
Select the corresponding element of the multifunction display
the information system.
›
Select the desired memory.
›
Press and hold button or adjustment wheel
B
The following values of the selected memory are set to zero.
›
Average fuel consumption.
›
Distance driven.
›
Average speed.
›
Driving time
Note
Disconnecting the vehicle battery will delete all memory data.
Information overview

First read and observe the introductory information and safety warn-
ings on page 25.
The amount of information displayed may differ depending on the equipment.
Outside temperature
The current outside temperature is displayed.
For vehicles with a MAXI DOT display this information is always shown.
Driving time
The time travelled since the memory was last erased is displayed.
If you want to measure the time travelled from a particular moment in time, reset
the memory to zero at that point in time
The maximum time indicated in both memories is 19 hours and 59 minutes and on
vehicles which are fitted with a MAXI DOT display, it is 99 hours and 59 minutes.
The indicator is set back to zero if this period is exceeded.
Current fuel consumption
The current fuel consumption level is displayed in litres/100 km
information to adapt your driving style to the desired fuel consumption.
1) On some models in certain countries, the display appears in kilometres/litre.
2)
On some models in certain countries, – -.- km/ltr. is displayed when the vehicle is stationary.
26
Using the system
» page 22, Using
» Fig. 7 on page 22.
D
» page 25, Memory.
1) . You can use this
The display appears in litres/hour if the vehicle is stationary or driving at a low
speed .
2)
Average fuel consumption
The average fuel consumption since the memory was last erased is displayed in
litres/100 km .
1)
If you wish to determine the average fuel consumption over a certain period of
time, you must set the memory at the start of the new measurement to
zero » page 25, Memory. After erasing the memory, no value is displayed until you
have driven approx. 300 m.
The display is updated regularly while you are driving.
Range
The range indicates the distance you can still drive with your vehicle based on the

level of fuel in the tank and with the same style of driving as before.
The display is shown in steps of 10 km. After lighting up of the indicator light
the display is shown in steps of 5 km.
The fuel consumption over the last 50 km is used to calculate the information.
The range will increase if you drive in a more economical manner.
If the memory is set to zero (after disconnecting the battery), a fuel consumption
of 10 l./100 km is calculated for the range; afterwards the value is updated ac-
cording to the style of driving.
Distance travelled
The distance travelled since the memory was last erased is displayed.
If you want to measure the distance travelled from a particular moment in time,
reset the memory to zero at that moment in time
The maximum distance indicated in both memories is 1 999 km or 9 999 km on
vehicles with a MAXI DOT display. The indicator is set back to zero if this period is
exceeded.
Average speed
The average speed since the memory was last erased is displayed in km/hour .
To determine the average speed over a certain period of time, set the memory to
zero at the start of the measurement
After erasing the memory, no data will appear for the first 300 m driven.
» page 25, Memory.
» page 25, Memory.

