Table of Contents
Advertisement
MS XX07 Series Integration Guide
MS 2207 Electrical Interface
lists the pin functions of the MiniScan MS 2207 interface.
Table 6-1
Pin
Pin Name
No.
1
Trigger
2
TXD
3
RXD/D+
4
SYN_CLK
5
Ground
6
Power
7
CTS/D-
*I = Input
O = Output
6-2
Figure 6-1. MiniScan Connector
Table 6-1. MS 2207 Electrical Interface
Type*
I
Signals scanner to begin scanning session.
O
Serial data transmit output. Drives the serial data receive input on
the device communicating with the scanner.
I/O
RS232 Mode: Serial data receive input. Driven by the serial data
transmit output on the device communicating with the scanner.
USB Mode: D+ signal. During USB operation this signal is pulled
up by a 1.5k Ohm resistor to begin USB enumeration. In this mode
it is a differential bi-directional signal.
I/O
Synapse Mode: Synapse Clock line. Signal used as a clock by a
Symbol Synapse host. Pin is shorted to RTS/SYN_DAT in USB
cables to allow autodetection of USB mode via signal loopback.
Power supply ground input and signal ground reference.
5.0 VDC ± 10%
I/O
RS232 Mode: Clear-to-send handshaking input line, used only in
conjunction with the RTS line. Optionally used by another device to
signal the scanner to begin transmitting data.
USB Mode: D- signal. During USB operation this signal works in
conjunction with the D+ signal as a differential bi-directional signal.
Function
Advertisement
Table of Contents
