Setting Up the Digital Scanner
Installing the Interface Cable
Plug the interface cable modular connector into the cable interface port on the bottom of the scanner
1.
handle. (See
Figure
Gently tug the cable to ensure the connector is properly secured.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on
3.
host connections).
Installing the Cable
Figure 1-2
Different cables are required for different hosts. The connectors illustrated in each host
NOTE
chapter are examples only. Connectors vary from those illustrated, but the steps to connect the
digital scanner remain the same.
Removing the Interface Cable
Using the tip of a screwdriver, depress the cable's modular connector clip.
1.
Removing the Cable
Figure 1-3
Carefully slide out the cable.
2.
Follow the steps for
3.
1-2.)
Clip
Cable interface port
Interface cable modular
connector
To host
Installing the Interface Cable
to connect a new cable.
Getting Started
1 - 3