Installing Your Phone; Charge The Battery - Uniden XDECT 5135 series Owner's Manual

Charge the Battery

1) Unpack all handsets, battery packs, and battery
covers. If any battery cover is already on the
handset, press in on the notch and slide the
cover down and off.
2) Line up the red and black wires on the battery
pack with the label inside the handset.
3) Push the connector in until it clicks into place; tug gently on the wires
to make sure the battery pack is securely connected.
4) Place the cover over the battery compartment and slide it up into
place.
5) Connect the base AC adaptor to the ADAPTOR jack on the rear of the
base.
6) If you have accessory handsets, connect a charger AC adaptor to
each charger's DC IN 9V jack and set the plug into the notch as
shown.
7) Plug the other end of each adaptor into a standard 240V AC power
outlet.
8) Place a handset in the base and any accessory handset(s) in the
charger(s) with the display(s) facing forward. The ChARGE light on the
handset(s) should turn on.
If...
the ChARGE light
does not turn on
# Charge all handsets completely (about 15-20 hours) before using
them.
6

INSTALLING YOUR PhONE

Try...
• reseating the handset
• checking the AC adaptor connection
• seeing if the outlet is controlled by a wall switch