Uniden XDECT 5135 series Owner's Manual page 10

6. When your phone accepts the Bluetooth connection, the XDECT 5135
sounds a confirmation tone. The Bluetooth device number icon on the
base and the handset display light up.
# Most mobile phones automatically transfer the audio to a
Bluetooth device as soon as it pairs; if yours does not, look in your
mobile phone's Bluetooth setup for a "transfer audio" or "send
audio to device" option.
To Test the Connection
1. Pick up the handset from the cradle.
2. Dial the number you want to call, then press MOBILE on the handset.
You may not hear a dial tone or ringing, but the handset display says
Talk.
3. Make sure the call connects and you can hear clearly. (When you're
finished, press END/CLEAR to hang up.)
4. The XDECT 5135 remembers the pairing information for your mobile
phone; if it loses connection with your phone for any reason (e.g., the
mobile phone travels out of range, runs out of charge, etc.), the XDECT
5135 can automatically reconnect the next time your phone becomes
available.
Using the XDECT 5135 with four Bluetooth phones
• The XDECT 5135 can save the pairing information for four different
Bluetooth phones, but it can only use one mobile line at any given time.
For example, if you pair the XDECT 5135 to four Bluetooth phones,
when you press MOBILE on the handset, the XDECT 5135 asks which
phone you want to connect to.
• If you are using the XDECT 5135 to talk on one Bluetooth phone, the
XDECT 5135 will not ring if a call comes in on another phone.
• To pair another Bluetooth phone, just repeat the pairing procedure with
the new phone. (If the paired phones interfere when you're pairing the
new one, just turn off Bluetooth on any paired phones until you finish
pairing the new one.)
10