Getting Started; Installing Your Phone; Getting To Know Your Phone - Uniden DECT1363 series User Manual

GETTING STARTED

Installing Your Phone

Charge the Battery
1. Unpack the handset, battery pack, and battery cover. If you need to remove the cover, press in on the notch and slide the
cover down and off.
2. Line up the battery connector with the jack inside the handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug gently on the wires to make sure the battery pack is securely connected.
4. Replace the battery cover and slide it into place.
5. Use the AC adapter to connect the power jack on the base to a regular indoor (120V AC) power outlet.
6. Place the handset in the base with the display facing forward. If the display doesn't light up, reseat the handset or connect
the base to a different outlet.
Charge the handset completely (about 15 hours) before using.
#
Connect the Telephone Cord
Use the telephone cord to connect the
If the display says Check Tel Line, check the connection between the base and the phone jack.
#
Test the Connection
Make a quick test call. Pick up the handset and press
x If there's a lot of noise, check for interference (see p. 6).
x If you keep hearing a dial tone, change to pulse dialing (see below).
Changing from Tone to Pulse Dialing
Your phone uses tone dialing by default. If your phone company uses pulse dialing, you need to change your phone's dial mode.
1. Press and select Global Setup.
MENu/sELEcT
2. Select Dial Mode then Pulse. You'll hear a confirmation tone.
To send DTMF tones during a call (e.g., for an automated response system), press
you hang up, the phone automatically returns to pulse dialing.

Getting to Know Your Phone

FIND
Charging
contacts
Handset
Key (icon) What it does
x In standby or during a call: open the CID list.
caLLEr Id/
x In any menu or list: go to the next screen.
rIGhT
x In standby: access your voice mail service.
x During a call: mute the microphone.
MEssaGE/
x While the phone is ringing: ignore this call (mute
MuTE/cLEar
the ringer).
( )
x When entering text or numbers: erase the
character at the cursor (press and hold to erase
all characters).
2 - English
jack on the base to a standard telephone wall jack.
TEL LINE
TaLk/fLash
Status
Earpiece
Base
Key What it does
In standby: page the handset.
fINd
. (Press to hang up.)
ENd
*
to temporarily switch to tone dialing. When
CALLER ID/
Display
12-key dial pad
END
RIGHT
PHONEBOOK/ TALK/ UP/DOWN
LEFT FLASH
Key (icon) What it does
x During a call: hang up.
ENd
x In any menu or list: exit and go to standby.
x In standby: open the redial list.
rEdIaL/
x While entering a phone number: insert a
pausE
2-second pause.
MESSAGE/
MUTE/CLEAR
Microphone
REDIAL/
PAUSE
MENU/
SELECT