Mx-Pnx1A/B/C/D (Punch Module) - Sharp MX-4110N Installation Manual

[10] MX-PNX1A/B/C/D (PUNCH MODULE)

MX-5111N
1. Unpacking
A. Removal of the punch unit
B. Removal of the fixing tape
MX-5111N MX-PNX1A/B/C/D (PUNCH MODULE) 10 – 1
Service Manual
C. Packed items check
1
No. Name
1 Punch position label (For scanner)
2 Punch position label (For RSPF/DSPF)
2. Installation
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
NOTE: When the punch unit is installed together with installation of
the inner finisher, first install the inner finisher, and then
install the punch unit.
Do not install the punch unit first because doing so would
cause interference between the inner finisher slide rail and
the punch unit drawer connector (possibly resulting in fail-
ure) when you attempt to install the inner finisher.
A. Installation of the punch unit
1) Open the front cover and slide the inner finisher to the left.
2
Quantity
1
1
2