Table of Contents
Advertisement
2)
Attach the protect sheet.
75 5mm
(4) Heater harness unit attachment
1)
Attach the snap band of the heater harness unit. While holding
the harness upward, attach the AC cord fixer.
NOTE: After attaching the snap band, cut and trim the end of the
band.
NOTE: Be careful not to mistake the attaching direction of the AC
cord fixer.
1
2
2)
Pull the harness tightly in the arrow direction, and check to
confirm that there is no disconnection of the snap band and
that the square hole in the frame is not covered with the har-
ness.
3)
Connect the connector of the heater harness unit, and attach
the earth wire.
NOTE: Attach the earth wire at an angle of 45 degrees.
(5) Cabinet and heater cover attachment
1)
Attach the cabinet.
2)
Attach the heater cover.
MX-5111N Dehumidifying heater 3 – 10
45
1
2
2
1
Hide quick links:
Advertisement
Table of Contents
