Table of Contents
Advertisement
: '11/Jul/25
1
3)
Import the setting file for HID card reading to the machine.
a)
Enter the system settings menu as shown below:
HomeSettingsUser ControlAdministrator Login
Card Area Setting
b)
Connect the USB memory to the USB connector in the
operation section.
c)
Select the file made in procedure 1) above.
d)
Press [Execute] button.
(The setting file for HID card reading is loaded.)
4)
Perform the operation check.
a)
While holding the IC card over the IC card reader, press
[Execute] button of "Card Scan Test".
b)
The IC card data are loaded. The test result is displayed
as shown below:
Display when loading is successfully completed:
Read Success.
Card ID : XXXXX
Facility Code : XXXXX
Display when loading is failed:
Detail of error
Error display
Error content and remedy
Card is not
Content
The card is not detected.
found.
Remedy
Check to confirm that the card is securely
inserted into the IC card reader.
Read Error.
Content
A read error occurs.
Remedy
Check to confirm that the card and the card
reader operate normally with a personal
computer, etc.
When an error occurs, troubleshoot the cause and remove the trou-
ble. Then perform the above procedures again.
Possible causes for an error may be error of the IC card or
improper contents of the setting file for HID card reading.
3.
Setting file for HID card reading
A. Overview
This manual describes the following setting procedures for reading
data from an IC card by using the HID card reading function:
• Setting of the reading area of card data
• Setting for assignment of read data to the card ID and the facility
code
* If the above setting procedures are not completed, the default
setting is valid, reading all the data in the card and assigning to
the card ID.
The brief steps of the setting are:
• Make the setting file according to the format specified in this
manual.
• Import the setting file through web page or by using the system
setting of the machine, "HID user area setting"
Incase of System setting mode:
User control > Card area setting > Importing from the setup file
B. Format of the setting file
The format of the setting file should be as shown below:
Section name
Key name = Key value
* Use the template setting file, change the key value, make an
arbitrary file name with an arbitrary extension (such as .ini), and
save the file.
• A line started with "#" or ";" is treated as a comment.
• A blank line may be inserted.
• Use one-byte alphanumeric characters only (except for comment
lines).
• A one-byte space may be inserted in front of and at the back of
"=" which connects the key name and the key value.
• Characters for the key value are case-insensitive. ("ABCD" is
considered as the same as "abcd".)
The section name (which is not changed in principle) and the key
name must be distinguished each other.
• The size of the setting file must be 4KByte or less.
• For the keys which are not set, the column of the value must be
blank or the whole line may be deleted (commented out).
C. Descriptions on the setting file
(1) Setting of the general information
Section name
General
Key name
Version
Card
*1: This manual describes only the setting of the HID card.
MX-5111N IC card reader 32 – 7
Description
Setting of the general information
[General]
Description
Setting file version (* Fixed to 1.0)
Set as shown below depending on the kind of the card to be
set.
*1
Key value
Description
Felica FeliCa
Card
Hid HID
Card
Hide quick links:
Advertisement
Table of Contents
