12. Network Setup - Onkyo TX-NR535 Advanced Manual

Setting Item Default Value
InstaPrevue -
Sub Window Multi
Position Bottom/LowerR
Setting Details
This function is related to the preview thumbnails
of the video input through HDMI, which will be
displayed using "InstaPrevue" in the Home menu.
⿠ Depending on the video source, the preview
thumbnails configured in "InstaPrevue" may
not be displayed properly.
Allows you to set how to display preview
thumbnails.
"Multi": Displays all the thumbnails of HDMI IN 1,
2, 3, 4 and 5 at once.
"Single": Displays thumbnails of HDMI IN 1, 2, 3,
4 and 5 individually.
Allows you to set the display position of preview
thumbnails.
When setting "Sub Window" to "Multi": Select
from "Top", "Bottom", "Left" and "Right".
When setting "Sub Window" to "Single":
Select from "UpperL", "UpperR", "LowerL" and
"LowerR".

12. Network Setup

Make the network setting.
⿠ When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
component, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item Default Value
Network Standby Off
Wi-Fi Off
Wi-Fi Setup -
Wi-Fi Status -
MAC Address -
Advanced Settings
Setting Details
This function allows you to turn on the power of
the AV receiver via network using an application
such as Onkyo Remote.
"On": When using this function
"Off": When not using this function.
⿠ When "Network Standby" is used, the power
consumption increases even when the AV
receiver is on standby. However, the increase
in power consumption is kept to a minimum by
automatically entering the HYBRID STANDBY
mode, where only the essential circuit is
operating.
Allows you to connect the unit to Internet via
wireless LAN router.
"On": Wireless LAN connection
"OFF": Wired LAN connection
Allows you to configure wireless LAN settings by
pressing ENTER when "Start" is displayed.
Displays the information of the connected access
point as follows.
"SSID": SSID of the connected access point.
"Security": Security method of the connected
access point.
"Signal": Signal strength of the connected access
point.
"SSID": SSID of the connected access point.
This is the MAC address of the AV receiver.
This value is specific to the component and
cannot be changed.
27