Operating Other Components With The Remote Controller; Functions Of Remote Mode Button; Programming Remote Control Codes - Onkyo TX-NR535 Advanced Manual

Operating Other Components with
the Remote Controller

Functions of Remote Mode Button

REMOTE MODE button on the remote controller has ability
to control your other AV components, including those made
by other manufacturers, by programming the specified
remote control code. Program the desired REMOTE
MODE button with remote control code and then press
the programmed button. The remote controller's mode is
changed to operate the corresponding component.
¼ The RCV and ZONE2 buttons cannot be programmed. ¼

Programming Remote Control Codes

For information on the configuration and operation of
Onkyo components with RI jack, refer to "Connecting
and Operating Onkyo RI Components". Furthermore, the
following REMOTE MODE buttons are preprogrammed with
remote control codes.
BD/DVD: Onkyo Blu-ray Disc/DVD player
TV/CD: Onkyo CD player
STB/DVR: Apple TV
■ Registration
1.
Look up the Remote Control Code List for the
corresponding remote control code.
30
⿠ The codes in the Remote Control Code List are
those known as of the date of publication and may
be changed.
⿠ Only TV remote control codes can be entered for TV.
⿠ Program a remote control code in accordance
with the input since each button also works as the
input selector. (For example, when the CD player is
connected to the TV/CD jack, program the remote
control code for the CD player to TV/CD)
2.
Press DISPLAY for 3 or more seconds while holding
down the REMOTE MODE button to which you want to
register the remote control code.
The remote indicator will light.
3. With the number buttons, enter the 5-digit remote control
code within 30 seconds. The registration is complete
when the remote indicator flashes twice.
⿠ The remote indicator flashes once when registration
fails. In that case, try the registration again.
Remote Control Code List

Operating Other Components with the Remote Controller

■ Remapping the Colored Buttons
The colored button assignment on the AV receiver's remote
controller can be remapped to match that on the remote
controller of the component whose remote control code you
programmed to REMOTE MODE. However, you will not be
able to remap the colored buttons if Zone 2 is selected.
1.
Hold down the REMOTE MODE button to map and A
(Red) simultaneously until the remote indicator lights
(about 3 seconds).
⿠ Remapping is possible only for codes included in the
categories of the Remote Control Code List such as
DVD player and TV.
2.
Within 30 seconds, press the colored buttons from left
to right, in the order you want to remap. For example, if
the colored buttons on the remote controller of the other
component are yellow, green, blue, and red from left
to right, press the buttons on the AV receiver's remote
controller in that order. Programming is complete when
the remote indicator flashes twice.
⿠ The remote indicator flashes once slowly when
remapping fails. Try the remapping again.
⿠ Pressing any other button than a colored button
cancels the remap operation.