Mercedes-Benz C-Class Operator's Manual page 329

Shift the transmission to position P.
X
Make sure that the vehicle level is set to
X
"Normal" on vehicles with AIRMATIC
( page 176).
Y
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove
X
the SmartKey from the ignition lock.
Vehicles with KEYLESS-GO start-func-
X
tion or KEYLESS-GO: open the driver's
door.
The on-board electronics now have status
0. This is the same as the SmartKey having
been removed.
Vehicles with KEYLESS-GO start-func-
X
tion or KEYLESS-GO: remove the Start/
Stop button from the ignition lock
( page 138).
Y
Make sure that the engine cannot be star-
X
ted via your smartphone (
If included in the vehicle equipment,
X
remove the tire-change tool kit from the
vehicle.
Safeguard the vehicle against rolling away.
X
Securing the vehicle to prevent it from
rolling away
If your vehicle is equipped with a wheel chock,
it can be found in the tire-change tool kit
( page 285).
Y
The folding wheel chock is an additional
safety measure to prevent the vehicle from
rolling away, for example when changing a
wheel.
Fold both plates upwards :.
X
Fold out lower plate ;.
X
Guide the lugs on the lower plate fully into
X
the openings in base plate =.
Securing the vehicle on level ground
On level ground: place chocks or other
X
suitable items under the front and rear of
the wheel that is diagonally opposite the
page 140).
Y
wheel you wish to change.
Securing the vehicle on slight downhill gradients
On light downhill gradients: place
X
chocks or other suitable items in front of
the wheels of the front and rear axle.
Raising the vehicle
G
If you do not position the jack correctly at the
appropriate jacking point of the vehicle, the
jack could tip over with the vehicle raised.
There is a risk of injury.
Only position the jack at the appropriate jack-
ing point of the vehicle. The base of the jack
Changing a wheel
WARNING
327
Z