Brake Pad Replacement; Brake Fluid Replacement - Suzuki GSX-R750 Service Manual

BRAKE PAD REPLACEMENT

• Remove the spring 1.
• Remove the brake pads by removing the clip 2 and pad mount-
ing pin 3.
#
* Do not operate the brake lever while dismounting the
pads.
* Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
• Install the new brake pads.
! Pad mounting pin: 16 N . m (1.6 kgf . m, 11.6 lb-ft)
NOTE:
After replacing the brake pads, pump the brake lever few times to
check for proper brake operation and then check the brake fluid
level.

BRAKE FLUID REPLACEMENT

• Place the motorcycle on a level surface and keep the handle-
bars straight.
• Remove the brake fluid reservoir cap and diaphragm.
• Suck up the old brake fluid as much as possible.
• Fill the reservoir with new brake fluid.
• Connect a clear hose to the caliper air bleeder valve and in-
sert the other end of hose into a receptacle.
• Loosen the air bleeder valve and pump the brake lever until old
brake fluid flows out of the bleeder system.
• Close the caliper air bleeder valve and disconnect a clear hose.
Fill the reservoir with new fluid to the upper mark of the reser-
voir.
N Specification and Classification: DOT 4
#
Bleed air from the brake system. (
 
 2-22) 
CHASSIS 6-61