Inspection And Disassembly; Reassembly And Remounting - Suzuki GSX-R750 Service Manual

INSPECTION AND DISASSEMBLY

Inspect the removed parts for the following abnormalities.
* Handlebars distortion
* Race wear and brinelling
* Bearing wear or damage
* Abnormal noise of bearing
If any abnormal points are found, replace defective parts with the
new ones.
• Remove the steering stem lower bearing inner race with a chisel.
#
The removed bearing outer race must be replaced with a
new one.
• Drive out the steering stem bearing outer races, upper and
lower, using a suitable wedge bar.
#
The removed bearing outer race must be replaced with
a new one.

REASSEMBLY AND REMOUNTING

Reassemble and remount the steering stem in the reverse order
of removal and disassembly.
Pay attention to the following points:
OUTER RACE
• Press in the upper and lower bearing outer races with the spe-
cial tools.
[ [ [ [ 09941-34513: Steering outer race installer set [
INNER RACE
• Press in the lower bearing inner race with the special tool.
[ 09925-18011: Steering bearing installer [ [ [ [
CHASSIS 6-31