SUSPENSION SETTING
After installing the rear suspension, adjust the spring pre-load
and damping force as follows.
SPRING PRE-LOAD ADJUSTMENT
The set length 186.5 mm provides the maximum spring pre-
load.
The set length 196.5 mm provides the minimum spring pre-load.
(STD length: 191.5 mm)
DAMPING FORCE ADJUSTMENT
(Rebound side)
Fully turn the damping force adjuster 1 clockwise. It is at stiffest
position and turn it out to standard setting position.
(STD position: 1 and µ turns out [Fine-tune the adjuster by turn-
ing it slightly until two punch marks align.])
(Compression side)
Fully turn the damping force adjuster 2 clockwise. It is at stiffest
position and turn it out to standard setting position.
(STD position: 1 and · turns out [Fine-tune the adjuster by turn-
ing it slightly until two punch marks align.])
STANDARD SUSPENSION SETTING
Softer
Solo riding
Standard
Stiffer
Dual riding
Spring set length
191.5 mm (7.54 in)
191.5 mm (7.54 in)
191.5 mm (7.54 in)
191.5 mm (7.54 in)
Rebound side
REAR
Damping force adjuster
Rebound
1 and ³ turns out
1 and µ turns out
1 turn out
1 and µ turns out
CHASSIS 6-49
Compression side
Compression
1 and ¸ turns out
1 and · turns out
º turn out
1 and · turns out