Electrical Work; Electrical Wiring - Samsung AP-3607BR Owner's Instructions & Installation Manual

ELECTRICAL WORK

ELECTRICAL WORK
The electrical work should be performed by a specialist qualified for the work.
●Use the single phase power supply, and be sure to install the sub power distributing board for
exclusive use with the unit(separately purchased by the user).
※Avoid octopus-type wiring as it can cause a drop in voltage, thus resulting in poor performance
of the automatic control circuit.
●Be sure to install the electric leakage breaker(separately purchased by the user).
●Be sure to connect the grounding wire.
Electric Power Spec
Power
Sub switch
Fuse
Below 20m
Electric wire
Below 50m
Allowable voltage
Indoor and Outdoor Connection Wiring
● When connecting the wiring harness between the indoor and outdoor unit, align the outdoor side
with the terminal board No., and insert the indoor side into the connector of the indoor wiring harness.
※ When the wiring harnesses of the indoor and outdoor unit are not properly connected, it may cause trouble.
Be careful not to allow the indoor and outdoor wirings and power lines to get in contact with the service valve
of the refrigerant system or to the pipe without an insulator. Fix the indoor and outdoor wirings to the
pipe covering the insulator.
1 2 3
RED WHT BLK

Electrical Wiring

1. Connect it to the terminal board No. 1 and No. 2 for power supply to the outdoor unit.
In so doing, peel off the end of the power cord by about 5mm, and press the cord to the ring
terminal for hooking.
2. Perform the power grounding using the screw for exclusive use with the outdoor unit.
SELECTION OF INSTALLATION PLACE/ELECTRICAL WORK
AP-3607BR
Single phase 208~230V,60Hz
AWG 10
AWG 9
INDOOR SIDE
1 2 3
Earth wire
Rojo Blanco Negro
1
2
3
Indoor wiring I ndoor/outdoor unit
connector
connecting wire
Electric panel board
1 2 3
RED WHT BLK
1
2
3
30A
30A
OUTDOOR SIDE
Terminal board
1 2 3 1 2
Rojo Blanco Negro
1
Earth wire
2
3
Electric panel board
27
E-