Before Calling The After-Sales Service - Samsung AP-3607BR Owner's Instructions & Installation Manual

Before Calling the After-Sales Service

Before calling for service, make a few simple checks as follows.
Problem
The air conditioner does
not operate at all
The air conditioner does
not operate with the
remote control
The air conditioner does
not cool
The fan speed does not
change when you
press the FAN SPEED
button
The air flow direction
does not change when
you press L/R SWING
The timer is not triggered
correctly
Smells are permeated in
the room during air
conditioning
The temperature display
on the indoor unit is
different from one on the
remote control.
If the indicators are111
displayed as below ;
Explanation/Solution
◆ Check that the power switch is turned ON.
◆ Check that the OPER. light on the indoor
unit is on; if necessary, press ON/OFF
◆ Check whether the TIMER light on the indoor
unit is on. If so:
- Wait until the start time is reached and the air
conditioner starts up automatically.
- Cancel the timer; see page 18.
◆ Check that there are no obstacles between you
and the indoor unit.
◆ Check the remote control batteries.
◆ Check that you are close enough to the indoor
unit (7 meters/23ft or less).
◆ Reset the remote control by pressing ACL
under the battery compartment cover with a
sharp end point.
◆ Check that the correct operating mode has been
selected AUTO or COOL.
◆ The room temperature may be too low.
◆ Dust may be blocking the air filter guard; refer
to page 20 for cleaning instructions.
◆ Check that there is no obstacle in front of
the outdoor unit.
◆ Check that the Operating Mode is set to
COOL or FAN; in the AUTO mode, the fan
speed changes automatically and in DRY mode,
it is set to AUTO.
◆ Check that the air conditioner has been switched
on.
◆ Check that you have set the clock to the right time;
see page 8.
◆ Check that the timer has been programmed
correctly; see page 16.
◆ Ventilate the room.
◆ The indoor unit and the remote control can be
◆ different each other, because the room
◆ temperature always is not equal.
◆ Turn the power switch off.
◆ Contact your installation specialist.
.
( )
21
E-