Table of Contents
Advertisement
INSTALLATION METHOD
INSTALLATION METHOD
Indoor Unit
This unit is greater in height compared to its width, and thus it may fall down.
Therefore, be sure to fix the unit to the wall and floor surfaces securely to prevent the unit from falling down.
Fixing to the floor
● Fix the unit using the installation plate separately supplied.
1. Place the indoor unit on the installation plate.
2. Remove the inlet grille of the indoor unit.
3. Fix the units to the nut of the installation plate at three
points using the hand bolt as shown on the right figure.
Fixing to the wall
●Fix the unit using the fixing holders separately supplied.
1. Bend the fixing holder as shown in the right figure.
2. Fix the fixing holder to the screw on the upper part of the
indoor unit.
3. Fix the unit to the wall surface using the screw or anchor bolt.
(The screw of the fixing holder is Ø6mm in diameter.)
Outdoor Unit
When using the anchor bolt
1.Fix the unit on a flat, rigid floor using the anchor bolt.
(Anchor bolt : M10 x 4 points - separately purchased)
When using the leg holder of the outdoor unit
1. Insert the foot holder (4EA).
2. Remove the nut fastened to the leg holder,
and then insert the leg holder into the hole of
the outdoor unit leg.
3. Fix the unit securely with the nut.
28
E-
Anchor bolt fixing dimensions
Unit : mm(inch)
Model
A
B
1
AP-3607BR
660(26)
335(13 5)
5
A
B
Nut
Outdoor unit leg
Leg Holder
Foot Holder
Advertisement
Chapters
Table of Contents
