Table of Contents
Advertisement
CC484/CC486/CC488 | Operators Manual | 21.
If you do not acknowledge the call from the
control panel during a pause between siren tones,
the control panel hangs up after 2 minutes and
calls the next telephone number.
Pressing the [*] key for 1 second to 3 seconds
during the pause acknowledges the call. No further
calls are made for that event. If the call was
successfully acknowledged, a tone of decreasing
pitch sounds.
Table 13: Domestic Dialling Telephone
Digits
Digit
Number to
Required
Program
0
0
1
1
2
2
3
3
4
4
5
5
6
6
7
7
20.2
Programming Domestic
Telephone Numbers
If your system is set up for domestic dialling, any
Master Code holder can program telephone
numbers that the control panel calls in the event of
an alarm.
How to Program Telephone Numbers
1. Enter your four character Master Code,
followed by the [2] and [#] keys (for example,
[25802#]).
Three beeps sound and the STAY and AWAY
indicators flash.
If there are telephone numbers already
programmed, they display one digit at a time
by the codepad indicators.
If there are no telephone numbers
programmed, two more beeps sound after
entering this mode. These two beeps normally
sound after the last digit of the last telephone
number displays.
2. Enter all digits for the first telephone number
(for example, [96721717]).
As each digit is entered, the corresponding
codepad indicators display.
3. If there is more than one telephone number to
program, press [*4]. This inserts a break
between the first telephone number and the
second telephone number. If there is only one
telephone number to program, press the [#]
key to exit this function.
Bosch Security Systems | 3/04 | SUB-MA48XO-3318
Digit
Number to
Required
Program
8
8
9
9
*
*1
#
*2
4-second
*3
Pause
Break
*4
Basic Pager Reporting
4. Enter all the digits of the second telephone
number (for example, [96721055]).
As each digit is entered, the corresponding
codepad indicators display.
5. After the last digit of the second telephone
number is programmed, press the [#] key to
exit this function unless a third telephone
number is required. If there is a third
telephone number to program, press the [*4]
button to insert a break between the second
telephone number and the third telephone
number.
20.3
Disable Domestic Dialling
To cancel domestic dialling (for example, you are
moving and do not want the system to continue
calling your mobile phone), enter the following
sequence.
1. Enter your four character Master Code,
followed by the [2] and [#] keys (for example,
[25802#]).
Two beeps sound and the STAY and AWAY
indicators flash.
2. Press the [*] key followed by the [4] and [#]
keys (for example, [*4#]).
The STAY and AWAY indicators are
disabled.
21.
Basic Pager Reporting
This feature only applies if your system reports to
a pocket pager. Basic pager reporting requires
some interpretation of the numbers appearing on
the display. It is possible to differentiate between
1000 different systems when a number of control
panels report to one pocket pager.
21.1
Basic Pager Display Information
Subscriber ID Number
This is the identification number of the control
panel, which can only be programmed by your
installer.
Zone Status
The zone status display shows the status of each
zone (1 to 8). Table 14 describes the meaning of
each number when it appears on the zone status
display.
EN | 17
Hide quick links:
Advertisement
Table of Contents
