Groomer Brush - Toro Greensmaster 3150 Service Manual

Groomer Brush

2
20 to 25 in- -lb
(2.3 to 2.8 N- -m)
1. Groomer brush shaft
2. Lock nut
The groomer brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
the groomer brush uses the same procedure as removal
and installation of the grooming reel (see Grooming
Reel in this section).
To remove the groomer brush from the shaft, remove the
lock nut and J--bolt from both ends of the brush and slide
the brush from the shaft. When assembling the brush to
the shaft, secure the assembly with J--bolts and lock
nuts. Make sure that the J--bolts are installed with the
threaded portion on the outside of the brush (Fig. 18).
Torque lock nuts from 20 to 25 in- -lb (2.3 to 2.8 N- -m).
Groomer
3
4
Figure 17
3. J- -bolt
4. Groomer brush
Page 8 - - 18
1
3
2
5. O- -ring
Figure 18
1. J- -bolt
5
20 to 25 in- -lb
(2.3 to 2.8 N- -m)
1
2
2. Lock nut
Greensmaster 3150