Toro Greensmaster 3150 Service Manual page 231

4. Remove grooming reel bearings and seals from
drive plate and support plate assemblies (Fig. 10):
A. Remove seals from groomer plates. Discard re-
moved seals.
B. Press bearings out of side plate housings. Dis-
card removed bearings.
Bearing Installation
1. Install new grooming reel bearings and seals into
drive plate and support plate assemblies (Fig. 13):
IMPORTANT: Bearings should be installed with ex-
tended inner races toward center of housing. Also,
apply pressure equally to inner and outer bearing
races when installing bearings.
A. Press new outer bearing fully to shoulder of drive
plate bore. Then, install new inner bearing until inner
race contacts outer bearing race.
B. Press new bearing into support plate until it is
flush with shoulder of bearing bore.
C. Install new seals into side plates. NOTE: Seals
should be installed so the lip side of the seal will face
the center of the cutting reel. When bearings are
greased, grease will purge from inner seals.
2. Install support plate to right side of cutting unit:
A. Apply antiseize lubricant to threads of RH groom-
er arm lift rod.
B. Position support plate to cutting unit making sure
that RH groomer arm lift rod is positioned through
bushing in support plate.
C. Place spring washer and lock nut on lift rod
threads (Fig. 12). Tighten lock nut.
D. Position motor mount to groomer support plate
(Fig. 11). Secure motor mount and support plate to
cutting unit with two (2) socket head screws and lock
nuts.
3. Install grooming reel, front roller and drive plate to left
side of cutting unit (see Grooming Reel Installation in
this section).
4. Check and adjust grooming reel height and mower
height--of--cut settings.
5. Install cutting unit to the machine.
6. Lubricate groomer bearings.
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe any ex-
cess grease from groomer shaft and seals.
Greensmaster 3150
4
2
1
1. Socket head screw
2. Motor mount
3. Groomer side plate (RH)
1 4
1. Front roller cap screw
2. Grooming reel assembly
3. Lock nut
2
1
5
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
4. Inner race
Page 8 - - 13
Figure 11
4. Cutting unit
5. Lock nut (2 used)
5
2
3
Figure 12
4. Spring washer
5. Groomer arm lift rod
3
6
5
5
8
7
Figure 13
5. Seal lip
6. Support plate bearing
7. Drive plate
8. Support plate
Groomer
5
3
1
4