Safety And Instruction Decals; Safety And Instruction Decals; Jacking Instructions - Toro Greensmaster 3150 Service Manual

Jacking Instructions

CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Front End Jacking
1. Apply parking brake and chock rear tire to prevent
the machine from moving. Make sure that cutting units
are fully lowered.
2. Position jack securely under the frame jacking point:
A. The left side jacking point is the frame channel
under the step behind the LH front wheel.
B. The right side jacking point is the ROPS support
bracket behind the RH front wheel (Fig. 1).
3. Jack front of machine off the ground.
4. Position appropriate jack stands under the frame as
close to the wheel as possible to support the machine.

Safety and Instruction Decals

Numerous safety and instruction decals are affixed to
the traction unit and the cutting units of the Greensmas-
ter 3150. If any decal becomes illegible or damaged, in-
stall a new decal. Part numbers are listed in your Parts
Catalog and Operator's Manual. Order replacement de-
cals from your Authorized Toro Distributor.
Greensmaster 3150
Rear End Jacking
1. Apply parking brake and chock both front tires to pre-
vent the machine from moving. Make sure that cutting
units are fully lowered.
2. Place jack securely below the rear castor fork.
3. Jack rear of machine off the ground.
4. Position appropriate jack stands under the frame to
support the machine.
1
1. ROPS support bracket
Page 1 - - 5
Figure 1
Safety