Advertisement
Quick Links
LED Work Light Kit
2015 and After—Cab and 2 Post ROPS Extension Kit
Model No. 31596
Note:
Determine the left and right sides of the machine from the normal operating position.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
Light assembly
Left mount (2 post ROPS extension)
Right mount (2 post ROPS extension)
Rear mount (2 post ROPS extension)
Cab mount
Carriage bolt (5/16 x 3/4 inch)
Flange nut (5/16)
Bolt (1/4 x 7/8 inch)
Flange nut (1/4 inch)
Bolt (6 mm x 20 mm)
Wire harness with grommet (cab)
Switch
Switch decal (2 post ROPS extension)
Register at www.Toro.com.
Form No. 3402-104 Rev B
Installation Instructions
Qty.
–
Prepare the machine before installation.
4
1
1
2
4
4
4
Install the lights.
4
4
4
4
1
1
Original Instructions (EN)
All Rights Reserved *3402-104* B
Printed in the USA
Use
Advertisement
Related Manuals for Toro 31596
Summary of Contents for Toro 31596
- Page 1 Form No. 3402-104 Rev B LED Work Light Kit 2015 and After—Cab and 2 Post ROPS Extension Kit Model No. 31596 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Installation Loose Parts Use the chart below to verify that all parts have been shipped.
-
Page 2: Installing The Lights
Installing the Light kit to the Cab Remove the bolts and nuts that secure the top of the headliner and set them aside (Figure Preparing to Install the Kit No Parts Required Preparing the Machine Move the machine to a maintenance workspace, shut off the machine and remove the key. - Page 3 Insert the grommets on the wire harness into the holes that you drilled. Remove the bracket on the light assembly and install the bracket supplied with the kit (Figure g033552 Figure 5 1. Flange nut 3. Bracket 2. Flat washer 4.
- Page 4 ROPS Extension Note: Ensure that your machine is equipped with the optional accessory-wire harness installed. Contact your authorized Toro distributor if your machine requires the accessory-wire harness. Install the light mount to the bracket. • For a machine with mirrors: Use the 4 bolts...
- Page 5 Remove the carriage bolt, washer and nut from the light assembly and use them to secure the light to the bracket (Figure 11). g033550 Figure 12 1. Wire harness Use the carriage bolt (5/16 x 3/4 inch) and flange nuts to secure the light assembly to the frame (Figure 13).
-
Page 6: Operation
g033598 Figure 16 1. Decal 2. Switch assembly Apply the decal to the panel as shown in Figure Connect the accessory-wire harness to the switch assembly. g033547 Figure 14 Connect the negative (-) battery cable. 1. Carriage bolt 4. Washer Turn the lights on. - Page 7 Notes:...