Toro Greensmaster 3150 Service Manual page 104

5. Rotate the motor clockwise so the motor flanges
clear the cap screws in the cutting unit side plates. Align
reel motor shaft splines with cutting reel insert splines.
Slide motor shaft into reel insert.
6. Rotate the motor counter--clockwise until the motor
flanges are encircling the cap screws. Tighten two (2)
flange head screws to secure reel motor to cutting unit.
7. Remove caps or plugs from hydraulic fittings and
hoses. Connect hydraulic hoses to reel motor (see Hy-
draulic Hose and Tube Installation in the General Infor-
mation section of this chapter).
8. After assembly is completed, verify that hydraulic
hoses and fittings are not contacted by any moving com-
ponents.
9. Check oil level in hydraulic reservoir and add correct
oil if necessary.
Hydraulic System
CENTER REEL MOTOR
FRONT
4
1. Center cutting reel motor
2. O- -ring
3. Hydraulic fitting
4. O- -ring
Page 4 - - 76
7
5
8
2
Figure 56
5. O- -ring
6. Hydraulic fitting
7. O- -ring
8. Hydraulic fitting
Greensmaster 3150
6
4
3
2
1