Operation - Jøtul GF 200 DV IPI Installation And Operation Instructions Manual

139587_05 GF 200 DV IPI October 2015

Operation

Important Notes
Check the build date on the shipping crate
label. If it has been more than 6 months
since the build date, be prepared to replace
the DFC batteries.
1. For the first several hours of operation, it is common
to detect some odor as the metal and manufacturing
materials cure under heat. This condition is temporary
and can be alleviated by allowing plenty of fresh air to
circulate through the area.
2. Condensation may develop on the glass upon each
lighting of the appliance. This "fog" will disappear as
the glass heats.
3. IMPORTANT: It will be necessary to clean the glass after
the first few fires. A white powdery residue will be
evident which results from the burner media curing.
Use a non-abrasive household glass cleaner and warm
water. IF THE GLASS IS NOT CLEANED, THIS RESIDUE
CAN CAUSE THE GLASS TO BECOME PERMANENTLY
ETCHED. DO NOT USE AMMONIA-BASED CLEANERS.
4. Keep the control compartments and area under the
appliance free of dust. Always keep the appliance area
clear and free from combustible materials, gasoline
and other flammable liquids.
5. This appliance can be operated with a continuously
burning pilot flame. Exercise caution when using
household products containing combustible vapors.
6. CAUTION: DO NOT OPERATE THIS APPLIANCE WITH
THE GLASS PANEL REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS SHOULD BE DONE BY
A LICENSED OR QUALIFIED SERVICE PERSON. USE
ONLY REPLACEMENT GLASS PROVIDED BY YOUR
AUTHORIZED JØTUL DEALER. NEVER SUBSTITUTE ANY
OTHER TYPE OF GLASS.
REMOVE GLASS ONLY FOR ROUTINE SERVICE. ALWAYS
HANDLE GLASS CAREFULLY.
WARNING:
READ AND UNDERSTAND ALL OPERATING
INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE
THIS APPLIANCE. DO NOT ALLOW ANYONE TO
OPERATE THIS APPLIANCE WHO HAS NOT READ
AND UNDERSTOOD THESE INSTRUCTIONS.
24
WARNING:
SEVERE INJURY. THIS APPLIANCE CAN BE SET TO
OPERATE THERMOSTATICALLY. BE AWARE THAT
THE FIREPLACE MAY BE VERY HOT EVEN WHEN
THE BURNER IS NOT APPARENTLY OPERATING.
KEEP CHILDREN AWAY FROM THE APPLIANCE.
WARNING:
OBSERVE CAUTION NEAR THE GLASS PANEL. THE
GLASS MAY SHATTER IF STRUCK BY AN OBJECT.
ALWAYS HANDLE THE GLASS PANEL WITH CARE.
DFC Battery Replacement
1. Switch Burner to OFF and disconnect power to the stove.
2. Access the battery box from under the gas valve. See
fig. 47 and 48a. Disengage the wire harness from the
retainer slot on the back of the DFC bracket. Disengage
the battery box from the hook & loop tape.
3. Slide the cover plate back to open the box. Install four, 1.5v
AA batteries and reattach the box to the underside of the
valve. Re-engage the wires with the retainer slot.
4. Reconnect power to the stove.
DFC
Harness
Figure 47.
Battery box to DFC wire harness connection. Tuck
harness up into the slot on the back of the DFC module.
DFC
Module
Bracket
Wire
Retainer
Slot
Battery Box
Harness