Philips Vari-lite VL3500 Wash User Manual page 90

❋
VARI LITE® - VL3500™ W
CAUTION: Do not touch patterns with bare fingers. Wear cotton gloves or other covering while
replacing or cleaning patterns. To clean patterns, use isopropyl alcohol and soft cloth.
Step 4. Rotate Yellow Wheel until cut-out faces up.
Step 5. Rotate Effects Pattern Wheel to desired pattern.
Step 6. At pattern's planet gear, gently rotate two planet gear latches that secure pattern planet gear.
Step 7. Remove planet gear containing the pattern from assembly.
Step 8. If replacing pattern, perform the following, if not proceed to Step 9.
a. At planet gear, rotate retaining spring from assembly.
b. Gently press pattern out from planet gear.
c. Install new pattern in same orientation (including black side up in the gear as shown in
Note: If installing same pattern in multiple fixtures, utilize same orientation (in relation to the planet
gear) in all fixtures.
d. Use care in reinstalling retaining spring. Spring can scratch pattern.
Step 9. Rotate rotating effects wheel until you see the small indexing hole in the sun gear.
Step 10. When reinstalling planet gear assembly, you must align the index mark in the planet gear
with the index mark (small indexing hole) in sun gear. Install pattern.
Step 11. Reengage two retaining latches. Ensure the latches are properly (and equally) positioned
over neighboring planet gear assemblies.
Step 12. Close the air-duct door.
Step 13. Replace bottom head cover.
72
L U
ASH UMINAIRE
Figure A-7 - reflective side must face lamp). This ensures all will calibrate in the same
orientation.
01 J un e 20 09
' M
SER S ANUAL
02 .9 686 .00 01 B