Philips Vari-lite VL3500 Wash User Manual page 75

Display
Fixture
FX Wheel
FX Index
Head Mtr
Inv Pan
Inv Tilt
Lamp
Lamp
Hours
Lamp Level
Lamp OFF
Lamp ON
Lum ID
Magenta
Manual
Movement
Normal
OFF
Off Time
OK
OK?
ON
Pan
Pan/Tilt
PASS
Power
Power Up
PROG
Re Cal
Reset
Default
Reset
Hours
RUN TEST
Sensor
Setup
Status
Strobe
02.96 86.000 1 B
Table 4-2: Menu Function Definitions (Continued)
Definition Purpose
Fixture Accesses luminaire information such as serial number, software version, and
total operation hours. Also accesses recalibration and download options.
FX Wheel Specifies FX wheel for manual control (Manual) or testing (Test).
FX Wheel Specifies FX index function for manual control (Manual) or testing (Test).
Head Motor Enables or disables pan/tilt movement.
Invert Pan Reverses pan action for special focus requirements.
Invert Tilt Reverses tilt action for special focus requirements.
Lamp Accesses lamp power-up options, reset and information (Config) or tests
Lamp function (Test).
Lamp Hours Displays total number of lamp operating hours.
Lamp Power Displays lamp power levels: 1500W, 1200W, or 900W.
Level
Lamp is Off Configures arc luminaire so that lamp will not strike upon power up.
Lamp is On Configures arc luminaire so that lamp will strike upon power up.
Luminaire ID Displays unique luminaire ID number.
Magenta Specifies magenta parameter for manual control (Manual) or testing (Test).
Manual Accesses options for luminaire mechanism control by entry of data values.
Movement Enables or disables pan and tilt movement.
Zoom Mode Zoom configuration is in normal mode.
Off Turns off a function.
Display off time Shows the automatic shut-off time for the menu display.
Okay Indicates calibration has completed and no errors have occurred.
Okay? Prompt for pressing [Enter] before an action is executed.
On Indefinitely Sets Menu Display to stay on until programmed otherwise (Display) or turns
on a function.
Pan Specifies pan function for manual control (Manual) or testing (Test).
Pan/Tilt Accesses pan and tilt options for focus swap function, movement enable/dis-
able, manual control and testing.
Test Pass Indicates that a test has passed.
Lamp Power Accesses options to turn lamp on or off.
Power Up Accesses options for lamp power up state.
Programming Currently programming the new version of software.
Recalibrate Recalibrates luminaire.
Reset Defaults Resets default system configuration values.
Reset Lamp Resets lamp hour and strike counters. (For use when new lamp is installed.)
Hours
Run Test Indicates that a mechanism test is in progress.
Sensors Accesses sensor types for diagnostic testing.
Setup Configures luminaire as Wash or Wash FX.
Status/Error Allows scrolling through error list or displays OK if no errors.
Strobe Specifies strobe function for manual control (Manual) or testing (Test).
M
ENU
01 J un e 20 09
S : M F
YSTEM ENU UNCTIONS
4
57