Addressing; Program Starting Address; Program Starting Address Without Calibrating Luminaire - Philips Vari-lite VL3500 Wash User Manual

❋
VARI LITE® - VL3500™ W

Addressing

Program Starting Address

The address setting for DMX console controlled systems is entered using the Menu Display (refer to
"Menu Operation" on page
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
Program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to enter starting address.
Step 4. Press [Enter] to set.
Program Starting Address Without Calibrating
Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.
Program starting address without calibrating luminaire or striking the lamp:
• While powering up luminaire, press and hold [Menu] until "Starting" is replaced by the current
DMX address in the menu display. Program address as in
Note: The luminaire will require a reset to restore control.
20
L U '
ASH UMINAIRE SER
50). The luminaire retains the DMX address even when power is removed.
01 J un e 20 09
M
S ANUAL
Program Starting Address above.
02 .9 686 .00 01 B