D-Link Xstack DGS-3600 Series User Manual page 239

Gigabit ethernet managed switch
Hide thumbs Also See for Xstack DGS-3600 Series:
Table of Contents

Advertisement

Configure the following Access Rule Configuration settings for IP:
Parameter
Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 to 128.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content, or IPv6 address.
This parameter is specified to re-write the 802.1p default priority previously set in the Switch, which
Priority (0-7)
is used to determine the CoS queue to which packets are forwarded to. Once this field is specified,
packets accepted by the Switch that match this priority are forwarded to the CoS queue specified
previously by the user.
Replace priority − Click the corresponding box to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this command,
before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming
802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 1 . Access Rule Configuration window (IP)
2
Auto Assign – Checking this field will instruct the Switch to automatically assign an Access ID
for the rule being created.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
IPv6 instructs the Switch to examine the IPv6 address in each frame's header.
222

Advertisement

Table of Contents
loading

Table of Contents