D-Link Xstack DGS-3600 Series User Manual page 238

VLAN Name Allows the entry of a name for a previously configured VLAN.
Source MAC Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC address.
802.1p (0-7)
Enter a value from 0 to 7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Ethernet Type
Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in
the form: hex 0x0-0xffff, which means the user may choose any combination of letters and
numbers ranging from a-f and from 0-9.
Port The Access Rule may be configured on a per-port basis by entering the port number of the
switch in the switch stack into this field. When a range of ports is to be configured, the Auto
Assign check box MUST be clicked in the Access ID field of this window. If not, the user will be
presented with an error message and the access rule will not be configured. The beginning and
end of the port list range are separated by a dash. For example, 3 specifies port 3. 2 - 4
specifies the range of ports from 2 to 4.
Rx rate Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1- 156249 or No Limit. The default
setting is No Limit.
Time Range Click the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range window. This will set specific times when this access rule will be
implemented on the Switch.
Counter
Click the check box and use the pull-down menu to employ the Counter that will count the
packets identified with this rule. Users must note that if the Counter is employed in the ACL Flow
Meter function, the Counter will automatically be disabled here, regardless of this setting.
To view the settings of a previously, correctly configured rule, click
below. Clicking the hyperlink for the Profile ID on the Access Profile Table will also bring up the Access Rule Display window.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 1 . Access Rule Display window (Ethernet) 1
in the Access Rule Table to view the window shown
221