D-Link Xstack DGS-3600 Series User Manual page 111

Parameter Description
Double VLAN Use the pull-down menu to enable or disable the Double VLAN function on this Switch. Enabling
State the Double VLAN will return all previous VLAN configurations to the factory default settings and
remove Static VLAN configurations from the GUI.
SPVID The VLAN ID number of this potential Service Provider VLAN.
VLAN Name The name of the VLAN on the Switch.
TPID The tagged protocol ID of the corresponding VLAN that will be used in identification of this
potential Double VLAN, written in hex form.
The user may view configurations for a Double VLAN by clicking its corresponding
read-only window.
Parameters shown in the previous window are explained below:
Parameter Description
SPVID The VLAN ID number of this potential Service Provider VLAN.
VLAN Name The name of the VLAN on the Switch.
TPID
The tagged protocol ID of the corresponding VLAN that will be used in identification of this
potential Double VLAN, written in hex form.
Uplink Ports
These ports are set as uplink ports on the Switch. Uplink ports are for connecting Switch VLANs
to the Service Provider VLANs on a remote source. Only gigabit ports can be configured as
uplink ports.
Access Ports These are the ports that are set as access ports on the Switch. Access ports are for connecting
Switch VLANs to customer VLANs. Gigabit ports cannot be configured as access ports.
Unknown Ports These are the ports that are a part of the VLAN but have yet to be defined as Access or Uplink
ports.
To create a Double VLAN, click the Add button, revealing the following window for the user to configure.
To create a Double VLAN, enter the following parameters and click Apply.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 7- 12. Double VLAN Information window
Figure 7- 13. Double VLAN Creation window
94
button, which will display the following