D-Link Xstack DGS-3600 Series User Manual page 200

The following parameters may be configured or viewed.
Parameter Description
Pool Name
Denotes the name of the DHCP pool for which you are currently adjusting the parameters.
IP Address Enter the IP address to be assigned to requesting DHCP Clients. This address will not be chosen
but the first 3 sets of numbers in the IP address will be used for the IP address of requesting DHCP
Clients. (ex. If this entry is given the IP address 10.10.10.2, then assigned addresses to DHCP
Clients will resemble 10.10.10.x, where x is a number between 1-255 but does not include the
assigned 10.10.10.2)
Netmask
Enter the corresponding Netmask of the IP address assigned above.
Domain Name Enter the domain name for the DHCP client. This domain name represents a general group of
networks that collectively make up the domain. The Domain Name may be an alphanumeric string
of up to 64 characters.
DNS Server Enter the IP address of a DNS server that is available to the DHCP client. The DNS Server
Address correlates IP addresses to host names when queried. Users may add up to 3 DNS Server
addresses.
Net BIOS
Enter the IP address of a Net BIOS Name Server that will be available to a Microsoft DHCP Client.
Name Server
This Net BIOS Name Server is actually a WINS (Windows Internet Naming Service) Server that
allows Microsoft DHCP clients to correlate host names to IP addresses within a general grouping of
networks. The user may establish up to 3 Net BIOS Name Servers.
NetBIOS Node This field will allow users to set the type of node server for the previously configured Net BIOS
Type Name server. Using the pull-down menu, the user has for node type choices which are Broadcast,
Peer to Peer, Mixed and Hybrid.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 57. Config DHCP Pool window.
183