Class A Chimney Retrofit - Lopi allegiance Owner's Manual

ADDENDUM #2 Class A Chimney Conversion Kit
Simpson Duravent provides a conversion kit for those wishing to use an existing wood stove chimney
to vent this direct vent stove. The illustration below gives an overview of this type of installation. See
the instructions included with the kit for details.
Warning The conversion kit does not work on interior masonry chimneys.
Warning Do not exceed the maximum vertical rise (see the section "Approved Vent
Configurations" starting on page 9) allowable. Remember to set the restrictor position to
the correct position (based upon the vertical rise height - see the chart on page 10).
Chimney Conversion Kit A (# 931)
Metalbestos 6" (150 mm) I.D.
Security Chimneys 6" (150 mm) I.D.
Jackes-Evans 6" (150 mm) I.D.
Hart & Cooley 6" (150 mm) I.D.
Pro-Jet 6" (150 mm) I.D.
Chimney Conversion Kit B (# 932)
Simpson Dura-Vent 6"(150 mm) I.D.
Air-Jet 6" (150 mm) I.D.
Metal-Fab 6" (150 mm) and 7" (175 mm) I.D.
Amer. Metals 6" (150 mm) & 7" (175 mm) I.D.
Metalbestos 7" (175 mm) and 8" (200 mm) I.D.
Jackes-Evans 7" (175 mm) and 8" (200 mm) I.D.
Hart & Cooley 7" (175 mm) and 8" (200 mm) I.D.
Pro-Jet 7" (175 mm) and 8" (200 mm) I.D.
Security Chimneys 8" (200 mm) I.D.
Travis Industries
Addenda
Screw the Retro
Vertical Top to the
Flex Pipe
Type A Chimney
4" (100 mm)
Aluminum Flex
Pipe
Retro Connector
(screw to chimney)
Simpson Duravent Direct
Vent Pipe Sections
(use adjustable section)
4041220
Chimney Conversion Kit C (# 933)
Simpson Dura-Vent 7" (175 mm) and 8" (200 mm) I.D.
American Metals 8" (200 mm) I.D.
Air-Jet 8" (200 mm) I.D.
Metal-Fab 8" (200 mm) I.D.
American Metals 8" (200 mm) I.D.
Each Kit Contains:
Retro Connector
Retro Vertical Top
Additional Equipment Required:
Termination (#991)
4" Flex (#711 or U.L. 1777)
Co-Axial Sections
Retro Vertical Top
(screw to chimney)
Cut the Flex Pipe to
the chimney height
plus 3" (75 mm)
Screw the Retro
Connector to the
Flex Pipe
39
9 3 5 0 8 1 2 3