Lopi allegiance Owner's Manual page 36

Optional Equipment
2 Place the blower near the rear of the stove. Attach the wiring in grommets following the directions
below.
f
Route the wires labeled "Valve
on/off" and "Solenoid" under
the burner pan to a location
near the gas control valve.
Attach the two wires leading
from the control box to the two
block wires labeled "Rheostat".
3 Slide the left side of the blower mounting bracket over the grommets on the left mounting bracket
attached to the stove (see the illustration below). Then insert the stud plate through the right side
grommets and through the right mounting bracket on the stove. Secure the stud plate with the
included washers and nuts
Right Mounting
Bracket (on stove)
Stud Plate
Blower Mounting Bracket
Stud Plate
11/32"
Socket
Travis Industries
e
Slide the rubber grommets (with
d
spacers inserted inside) onto the
fan mounting bracket.
Left Mounting
Bracket (on stove)
Washer
Nut
4041220
(Qualified Installers Only)
Remove one of the screws holding
a
the mounting bracket in place. Insert
the screw through the eyelet on the
green ground wire and replace.
1/4" Nutdriver
Attach the black and white wires
b
labeled "Blower" to the blower
(orientation does not matter).
c Attach the molex connector.
DO NOT PLUG THE STOVE
IN UNTIL INSTALLATION IS
COMPLETE.
Make sure the bracket
slides into the groove on
the rubber grommets.
Blower Mounting
Blower Mounting Bracket
Rubber
Grommet
Bracket
9 3 5 0 8 1 2 3
35