Complete The Installation - Vermont Castings 0003380 Installation And Operating Instructions Manual

Radiance Vent-Free Gas Heater
®
Right Rear Log
Left Rear Log
Left Bracket
Fig. 17 - Install the left and right rear logs and the right log.
LG156
Radiance logs
4/23/01 djt
Log rests on
decorative grate
Fig. 18 - Completed log installation.
LG155
5. Loosely sprinkle the lava rocks directly on top of the
Radiance logs
burner just behind decorative grate. (Fig. 19) Use the
installed
lava rock to cover brackets on the burner. Do not place
4/24/01 djt
lava rocks toward back of burner. The lava rock is
shipped inside the bag assembly.
Left Rear Log
Top View
Decorative Grate
Fig. 19 - Lava rock placement.
14
Right Log
Decorative
Right Bracket
Grate
Lava Rock
Right Rear
Log
Lava rock may
be placed in this
area
LG160
RNV logs
top view
6/4/01 djt

Complete the Installation

1. Replace the screen frame by sliding the hooks over the
top front edge of the firebox and resting the bottom on
the support brackets. Swing the top edge of the assembly
toward the firebox, and center it. Fasten it by closing the
latches over the top left and right edges of the frame.
2. Replace the stove front by grasping it by the left and
right edges. Lift it so that tabs on the back side of the
top corners engage notches at the top forward corners
of the stove sides. Then gently swing the bottom of the
front panel to a vertical position, and lower it till prongs
on its bottom left and right corners engage with notches
cast into the tops of the forward legs. (Fig. 20) Test that
the front is installed securely by grasping two of panel's
vertical bars, and pulling the panel toward yourself. When
the panel is in place properly you should not be able to pull
the bottom of the front toward yourself without also lifting it.
3. Attach the wooden handle to the control door using the
#8-32 x 2" screw from the parts bag. (Fig. 21)
4. Set the screen and the cast-iron grate into the recess in
the stove top.
This completes the installation and assembly of the
Radiance.
Fig. 20 - Replace the front panel.
Fig. 21 - Attach the handle to the control door.
ST139a
Radiance
replace front
7/24/01 djt
ST197
RUVS attach accessory door handle
7/01
30005056