4.2.3.24 Remove the Stay-Guide-L-Assy
(1) Remove the scanner. (See Sub 4.2.1)
(2) Remove the left side cover. (See Sub 4.2.3.1)
(3) Remove the two screws (silver)
(4) Remove the three screws (silver)
(5) Unthread the cables from the Guide Cable.
(6) Remove the Plate-Shield-Front(n). (See Sub 4.2.3.16)
(7) Unplug the connectors
(8) Disconnect the cable carefully not to deform the Shield-Clamp-Base.
<Instruction on reassembly>
To clamp the cable between the Shield-Clamp-Base and the Shield-Clamp, be sure to clamp the
part of the cable wrapped with a conductive tape.
Y108500-4
to remove the Shield-Clamp.
to remove the Stay-Guide-L-Assy.
to
from the PUCU board.
Shield-Clamp-Base
PUCU-PCB
Service Manual
91