4.10 Wireless LAN board/Modem Daughter Card
4.10.2 Modem Daughter Card
CAUTION: The power must be turned off when you remove the modem daughter card.
Removing the modem daughter card with the power on risks damaging the
card or the computer itself.
Removing the Modem Daughter Card
To remove the modem daughter card, follow the steps below and refer to figure 4-17.
1. Remove the following screws securing the modem daughter card.
• M2×4Z
2. Lift up gently the modem daughter card perpendicularly to disconnect it from the
connector PJ3000 on the system board.
CAUTION: When removing/installing the modem daughter card, be sure to hold the
modem daughter card by both the edges right above the connector PJ3000.
3. Disconnect the modem cable from the connector on the modem daughter card.
Satellite A40 Maintenance Manual (960-458)
BIND screw
M2 × 4Z BIND
PJ3000
Figure 4-17 Removing the modem daughter card
×2
MDC
Modem cable
4 Replacement Procedures
4-31