Toshiba Satellite A40 Series Maintenance Manual page 181

3 Tests and Diagnostics
(b) HDD Priority
Use this option to set the priority for booting of the computer when a device
connected via PC card is connected to the computer.
Built-in HDD→PC Card:
PC Card→Built-in HDD:
(c) Network Boot Protocol
Use this option to set the starting method via a network.
PXE
RPL
6. Display
This group of options configures the computer's display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected
LED+AnalogRGB
NOTE: When starting the computer in Resume mode, the last configuration is
remembered. If data does not appear on the display you are using after starting
in Resume mode, pressing Fn+F5.
Pressing Fn+F5 changes the display setting as follows in order: the internal
LCD, the external CRT, both the internal LCD and the external CRT and TV
display.
You cannot select TV display in HW Setup. To display on a TV screen, use
Fn+F5.
When an external CRT display which does not support SVGA mode is connected
and "LED+AnalogRGB" is selected, the external display is not displayed.
3-60
The computer looks for bootable files in the
built-in HDD first. (Default)
The computer looks for bootable files in the PC
card first.
Sets to PXE protocol. (Default)
Sets to RPL protocol.
Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
Selects both the internal LCD and the external CRT for
simultaneous display.
Satellite A40 Maintenance Manual (960-458)
3.23 SETUP