Toshiba Satellite A40 Series Maintenance Manual page 355

4.26 Fluorescent lamp
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
CAUTION: The GND-CU and lamp reflector on the left-hand side must not go beyond
the edges of the bezel.
Be careful not to damage the cables and TAB.
The bezel latches must be engaged (there are five latches on the top edge,
and two latches on the bottom edge).
Next, fit the bezel's edge
次にた Ｔ ＡＢ側をはめる ．
close to the TAB.
ラ ッチ ５か所 をはめる ．
Close the five latches.
ＧＮＤ－ＣＵ折 り曲げ有 り ． The fold of GND-CU
ベゼルの外に出ない こ と ．
must not go beyond the
The fold of reflector must not go
beyond the bezel's edge.
Figure 4-72 Replacing 14 Inch TMD fluorescent lamp (10)
Satellite A40 Maintenance Manual (960-458)
2
2
2
リ フレ ク タ折 り曲げ有 り ．
ベゼルの 外に出ない こ と
4 Replacement Procedure
2
2
1
First, fit the bezel's edge close to the
ベゼルを ラ ンプ 側か らはめる ．
lamp. Use care not to damage the
ケーブルをキズつけないよ うに注 意
bl
ラ ッチ ２箇所有 り ．
Two latches
4-89