Toshiba Satellite A40 Series Maintenance Manual page 127

3 Tests and Diagnostics
3. Select the test you want to execute and press Enter. When SYSTEM TEST is
selected, the following message will appear:
SYSTEM TEST
SUB-TEST
PASS COUNT : XXXXX
WRITE DATA : XX
ADDRESS : XXXXXX STATUS
SUB-TEST MENU :
01 - ROM checksum
02 – Geyserville
03 -
04 - Fan ON/OFF
05 –
06 - Quick charge
07 - DMI read
08 - DMI write
09 - Thermister Check
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your computer may be slightly different from the one
shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The
following message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and
restarts the test cycle.
Selecting NO returns to the subtest menu after the test is complete.
3-6
XXXXXXX
: XX
ERROR COUNT
READ DATA
3.2 Executing the Diagnostic Test
XXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C]
: XXXXX
: XX
: XXX
↑↓→← : Select items
Enter
Esc
Satellite A40 Maintenance Manual (960-458)
: key stop
: Specify
: Exit