Ricoh M016 Service Manual page 123

Engine Maintenance
Waste toner Independent-Supply
disposal Toner
Test Pattern Prints the test pattern.
Corrects the face curl of paper.
0: OFF (28ppm)
Curl Control 1: Sets the engine speed at 14ppm after printing 1 minute.
mode 2: Sets the engine speed at 14ppm.
3 to 255: not available
[0 to 255 / 0 / 1 /step]
Charge bias correction for dirty background
0: OFF (Default)
Adjust of
1: ON
Charge Bias
2 to 255: not available
[0 to 255 / 0 / 1 /step]
SM
Sets the machine operation at "waste toner full"
of the refilled AIO.
[On or Off (Default)]
With main motor rotation count feature,
machine can be set to stop printing after
print total exceeds a certain set value. If
print count exceeds this value, then
"Replace Print Cartridge" remains in
display. Then a new AIO cartridge must
be installed. This feature is a safety
measure to prevent the used toner tank
from becoming full (there is no toner
overflow detection mechanism).
5-11
Service Program Mode
M016/M017