Radio; Listening To Radio; Presetting Stations Manually; Presetting Stations Automatically - Alpine iDA-X303 Owner's Manual

01GB00iDAX303.book Page 8 Wednesday, October 29, 2008 11:19 AM

Radio

Double Action encoder
BAND TUNE/A.ME
SOURCE

Listening to Radio

1
Press SOURCE to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
FM1 FM2 AM FM1
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode)
(Blank) (Manual mode)
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or
continuously.

Presetting Stations Manually

1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press PRESET.
The Preset screen is displayed.
3
Turn the Double Action encoder to select the
preset number.
4
Press and hold /ENTER for at least 2 seconds.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
• A total of 18 stations can be stored in the preset memory (6 stations
for each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
8
-EN
01GB05iDAX303.fm
FUNCTION/SETUP
PRESET
/ENTER
SEEK (Local mode)
DX SEEK (Distance mode)
will change the frequency

Presetting Stations Automatically

1
Press BAND repeatedly until the desired radio band
is displayed.
2
Press and hold TUNE/A.ME for at least 2 seconds.
The tuner will automatically seek and store 6 strong stations
in the selected band. They will be stored 1 to 6 in order of
signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
• If no stations are stored, the tuner will return to the original station
you were listening to before the auto memory procedure began.

Tuning to Preset Stations

1
Press BAND repeatedly until the desired band is
displayed.
2
Press PRESET.
The Preset screen is displayed.
3
Turn the Double Action encoder to select a radio
station.
4
Press /ENTER.
The display shows the band, preset number and frequency
of the station selected.

Frequency Search Function

You can search for a radio station by its frequency.
1
Press /ENTER in Radio mode to activate
Frequency search mode.
2
Turn the Double Action encoder to select the
desired frequency.
3
Press /ENTER to receive the selected frequency.
• Press in the search mode to cancel. Or, the search mode will be
cancelled if no operation is performed for 10 seconds.
ALPINE iDA-X303 68-14470Z02-A (EN)