Grizzly G0700 Owner's Manual page 39

Rip Cutting with Rip Fence
1.
Lock the sliding table in a stationary position
in front of the saw. (The table will only lock in
place when it is centered in front of the saw
and the sliding table lock is in the locked posi-
tion (see Figure 50).
Sliding Table Lock
Lock
Position
Figure 50. Sliding table lock.
2. Place the fence in the vertical position for
larger workpieces, or in the horizontal posi-
tion for angled cuts and for small workpieces
(see Figure 51).
Figure 51. Rip fence positions.
Model G0700 (Mfd. Since 5/14)
3.
Unlock
Position
Figure 52. Edge of rip fence over scale indicates
4.
5.
6.
Vertical
Horizontal
Adjust the rip fence to the location necessary
for the width of cut, lining up the edge of the
rip fence where necessary on the scale (see
Figure 52), then locking the fence in place.
Edge of Fence
cutting width.
Load the workpiece onto the table saw. The
set up should look similar to Figure 48.
Adjust the height of the main blade
approximately ⁄ "– ⁄ " above the top of the
1 1
8 4
workpiece.
Take all the necessary safety precautions,
then perform the cutting operation as you
would with a traditional table saw (by sliding
the workpiece firmly along the fence until the
cut is complete).
-37-