Grizzly G0700 Owner's Manual page 27

25. Make sure the fence is just touching the edge
of the blade teeth, then adjust the position of
the rip fence scale until the edge of the fence
is aligned with the 0" mark on the scale. Once
it is aligned, carefully tighten the rip fence
scale fasteners.
26. Move the fence out of the way, and install the
blade guard (Figure 25) per the instructions
on Page 31. (This step is mandatory.)
Figure 25. Blade guard installed.
27. Install miter gauge as shown in Figure 26.
Miter Gauge
Figure 26. Miter gauge installed.
Model G0700 (Mfd. Since 5/14)
28. Install the hose support as shown in Figure
Blade Guard
27.
Hose
Support
Lock Washer
Flat Washer
10mm
10mm
Hex Nut
M10-1.5
Hose
Support
Cap Screw
M10-1.5 x 25
Figure 27. Hose support installed.
Large
Extension
Table
-25-